1, the pump is not absorbent or not drained. Caused most of this failure is due to the end of the valve stuck, part of the blockage of water filtration, suction height is too high or suction pipe leakage and so on. Should be checked one by one, respectively, to repair the end of the valve, remove the blockage, to correct the steering and other processing. 2, pipeline leakage or leakage. Mostly because the nut did not tighten. If the leak is not serious, you can smear grout, wet mud or soft soap at the leak; if the joint leaks, wrench can be used to tighten the nut. Severe water leakage, leaks, you must re-disassembly. 3, the pump violent vibration. It may be that the rotor is unbalanced or that the coupling is bad. Sometimes bearing wear, bending, rotating parts loose parts, rupture, pipe support is not strong will cause vibration. Should be adjusted, reinforcement, inspection or replacement. 4, impeller broken. Damage is not, you can repair. Serious damage should be replaced or plated with cemented carbide. Completely damaged, should remove the impeller, sent to the repair shop repair. 5, pump shaft bending. Mostly due to the impact load, too tight belt pulled, the installation is not correct and so caused. If the bend is not serious, manual screw can be used for correction, but the force can not be excessive, to prevent a complete break.
The super high pressure hydraulic pump is a construction tool for wire crimping, usually combined use with wire hydraulic crimper head. It is applied to provide power for the busbar machine, the hydraulic compressor, and other construction machinery, which is operated in the wild field in electric power, railway, rescue, construction and other industries.
10. Hydraulic oil tank is made of high strength alloy aluminium, which has good heat dissipation performance.
High Pressure Hydraulic Pump, Double Acting High Pressure Hydraulic Pump,Double Acting Gasoline Engine Hydraulic Pump Taizhou Haoxin Electric Power Machine Co., Ltd. , https://www.hxstringingequipments.com
1. Large oil capacity, the double acting gasoline engine hydraulic pumpsuitable for large capacity crimping tools and long time operation without engine overheating.
2. High and low double-speed automatic switch, well fit for 60T/100T/200T/300T crimping tools.
3. Rated output pressure 70Mpa, maximum up to 80Mpa.
4. Retract pressure protection system and overflow protection valve, safe and reliable.
5. Simple structure, easy operation, light weight.
6. Low noise, environment friendly.
7. Equipped with pressure gauge for easy output confirmation.
8. Double-loop design with high-low voltage and double-speed automatic switching system.
9. The double acting high pressure hydraulic pump has the function of adjusting pressure and keeping pressure, and has a good protective effect on crimping equipment.