We are not talking about ear rings or wedding rings,we are talking about End Fittings for Ratchet Straps.
These D shape rings,O shape rings as well as Delta Rings are all functioning the same:as end fitting for straps.
Before choosing the rings,please make sure the sizes of ratchet straps first,and then we shall get the rings accordingly.
Plus,if you need similar stuff but not for this function,please also let us know,we'll try to get it right for you,thank you!
O Rings & D Rings & Delta Rings O Rings,D Rings,Delta Rings WINNERLIFTING(H.K.)INT'L TRADING LIMITED. , https://www.massagebeds.nl
Japan Piston Rings Co., Ltd. exhibited "Continuous Variable Valve Actuater (CVVA)" at the 39th Tokyo Motor Show (open to the public from October 22 to November 6, 2005) , The valve can be continuously variable inlet valve on the engine. "Dramatically reduces pumping losses and improves fuel efficiency" (the company). Ordinary engines are through the throttle to adjust the intake and exhaust opening and closing. If this is the case, the low intake will reduce the amount of suction by closing the valve, which in turn will create drag due to the negative pressure in the intake manifold, resulting in losses. This is the pump loss. The engine equipped with CVVA does not open and close the throttle, but by virtue of the valve to adjust the amount of inhalation. A structure in which the first and second swing arms are transmitted by the motion of the suction cam and the accelerator connected to the second swing arm moves up and down. A "lever" is provided on the upper part of the second arm, and the tip of the lever is rotationally moved on the upper part of the second arm. Lever control lever position for the second swing arm pivot, so as to adjust the amount of valve lift. This configuration is envisaged to reduce the amount of intake air by reducing the amount of valve lift during low-speed rotation, and to increase the amount of intake air by increasing the amount of valve lift during high-speed rotation. The lever itself is driven by an actuator that uses a ball screw with a rotary motor. The company believes that for straight-line cylinder engines, for example, while all cylinders are equipped with control levers, only one actuator is required to drive all levers. However, "can not be directly built in the engine, you need to further reduce the size."